Welcome
 		About Us
 		Services
 		Solutions
 		equipment
 		Contact
 		 



Hi-Pressure Seal, Deep Well, High Head Dewatering Pumps where the discharge pipe and the head cover can be separated for greater convenience in pipe replacement and pump maintenance. A mechanical seal withstanding water pressures of up to 142 psi (0.98 MPa) is used in the 20 to 60 HP types. Also, a dual impeller has greatly increased the pumping power to realize high-head specifications.

Commercial, industrial dewatering and construction site drainage
 
Effluent transfer
 
Decorative waterfalls and fountains
 
Raw water supply from rivers or lakes
 
  
 Semi-open, High Chrome Iron impeller with replaceable/adjustable High Chrome Iron Wear rings, increases wear Resistance, when pumpage contains abrasive particles.
 
 Double inside mechanical seals with silicon carbide faces, (both top and bottom) running in an oil filled chamber and further protected by a lip seal running against a replaceable, 420 stainless steel shaft sleeve, provides for the most durable seal design available.
 
 Highly efficient, continuous duty air filled, copper wound motor with class B or F insulation, minimizes the cost of operation.
 
 Built in thermal & amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions.
 
  Double shielded, permanently lubricated, high temperature C3 ball bearings fated for a B-10 life of 60,000 hours, extend operational life.
 
 Top discharge, flow-thru design enables operation at low water levels for extended periods.
 









Copyright 2007 Patriot Pumps All Rights Reserved.
Unauthorized use of images and content is strictly prohibited.

A Patriot Pump Company
For our current catalog: Click Here
For more information: info@pumpexperts.com